A large area will never look as good as it did before it peeled, but it will look better than while it was peeling and it will stop it from peeling more. With larger areas, this is going to happen no matter what. You won’t notice the curl right away, until it starts to cure. The new epoxy will make the old epoxy finish curl back, so try not to get any on top of the old finish. Paint the epoxy on just the chip or where the old tub is showing through. It works great on small chips and cracks, but with some of the larger sections it felt like using a bottle of white-out to paint a wall. The part B bottle comes with a small brush similar to a nail polish brush for applying the epoxy. I wish I could have reused them for something else, but I wasn’t willing to risk dealing with the toxic chemicals from the epoxy, so I just tossed them.) To begin, mix part A and part B of the epoxy together. ![]() There were a couple larger spots that needed a second coat of epoxy, so those took a second hour, mostly in wait time. Luckily I could do the whole process (wash, dry, apply epoxy) in under an hour before we left on a weekend trip. The one downside is that Rust’Oleum Tub and Tile Touch-Up takes 3 days to cure, just like refinishing the whole bathtub. It feels wrong to be removing the finish and making the peel bigger but the touch-up will look and work better in the end if there are no loose bits. One more prep task that the package directions don’t mention but I suggest, is to remove any loose old finish. The epoxy does smell as bad as the Refinishing Kit epoxy, but because it’s a smaller amount, the smell isn’t nearly as strong. No sanding or harsh chemical cleaners needed. The only prep work you need to do is to wash the tub with soap and water, rinse, and let it dry. However, the whole process is much, much easier when you’re just touching up. It’s a two-part epoxy that you mix together just before applying. Rust-Oleum Tub and Tile Touch-Up seems to be the same epoxy product as Rust-Oleum Tub and Tile Refinishing Kit, just in a smaller amount. How to Repair a Chipped or Peeling Bathtub Luckily there is an easy way to fix any of these chips and peels and keep the tub looking clean and white. There’s also one spot where something heavy must have dropped because it chipped through the epoxy and the old green enamel, showing some cast iron. The epoxy cracks and peels have mostly been along the bottom of the tub walls, not on the floor of the tub. Again, I think it’s the prolonged exposure to water that causes the problem. We also have been using the bathtub for baths more often this last year and that’s affected the epoxy. I clean it the same way I would any other tub, and the color has not yellowed or stained at all, even with hair dye. The epoxy has stayed clean and white, though. Because we’ve gotten a few more peels along that same line. I think that water dripping off the shower curtain and pooling just a little along its edge weakened the epoxy. The directions for Rust-Oleum Tub and Tile say not to use it on anything with constant water immersion such as a swimming pool. Then, a year ago, the epoxy started to peel just a little in one spot along the edge of where the shower curtain hangs. ![]() We had a beautiful white bathtub that was easy to clean. So, how is the epoxy holding up?įor the first 2 years, it looked great. You can read all about my experience refinishing a bathtub with Rust-Oleum Tub and Tile here. To lighten up the room, we refinished the bathtub in white a few years ago. Our 1950s home had a green bathtub, greened tiled walls, and a green sink. If you have a chipped enamel tub, skip down to the next section to find out how to repair a chipped bathtub. It wouldn’t have made the chip disappear completely, but it would have filled in the jagged edges and made the chip unnoticeable unless you looked closely. It’s an easy fix that works great and lasts. I wish I had known about Rust-Oleum Tub and Tile Repair then. I tried filling the hole with caulking, but it looked terrible and after a while it came loose. I was told several times that once a bathtub is chipped, there’s nothing you can do. I researched everywhere to find out how to fix that chip, asked anyone who might know, and search the (very young) internet, but found nothing. So it was a sad day when, 2 months after we moved in, something was dropped on the edge of the bathtub making a huge chip in it. I loved moving into a home where everything was new the fridge, the sink, the carpet, the walls, the bathtub, everything was brand-new and undamaged. Our last house was a brand-new home, built just for us. If you click on those links, I may earn a small commission at no extra charge to you. This post has links to products I used to do this project.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |